Floor Coating: E8490 Two Pack Water Based Polyurethane DTS Gloss or Satin 4:1 Ratio - Fisher Group

Floor Coating: E8490 Two Pack Water Based Polyurethane DTS Gloss or Satin 4:1 Ratio

Is a two pack water borne epoxy coating with excellent film properties and surface hardness. It is a self priming and environmentally friendly coating system which is ideal as a floor coating, due to its excellent adhesion and chemical resistance. It can be tinted to an unlimited colour range.

 

$465.78

  • Next day delivery
  • Top quality products
  • Money back guarantee

E8490 Two Pack Water Based Polyurethane DTS Gloss or Satin 4:1 Ratio Coating

Is a unique high performance water borne two pack acrylic polyurethane with exceptional durability which may be used direct to concrete that has been thoroughly prepared. It provides ease of use and VOC compliance and is suitable for brush, roller or spray application. This environmentally friendly fast drying coating has very good yellowing and UV resistance on exterior exposure. It has good abrasion and chemical resistance.

Uses:

  • Seamless flooring
  • External concrete coating
  • Masonry
  • Carparks and Automobile Showrooms
  • Shopping Centres
  • May be used as an anti graffiti coating

Benefits:

  • Exceptional durability
  • Good hot tyre resistance
  • Suitable for brush, roller and spray application

Limitations:

  • Not to be applied below 10ºC and above 85% R.H.
  • Not to be applied to a hot surface
  • Excessive thickness could cause whitening
download technical data sheet
Sizes

10L

Theoretical Coverage

6.0 – 9.0m²/Litre @ 50 – 75µm(110 – 165µmWFT)

Application

Mixing – Stir Pack A, then blend Pack A with Pack B completely and power stir thoroughly for at least 2 minutes before thinning. Thin 5 – 10% with water if required. NB: Reseal hardener tin well if not fully used.
Note: thorough hand stirring may be suitable for small quantities.
Application Air or Airless Spray, brush, or roller. (A & I Coatings technical staff can advise on the most appropriate equipment for a specific task).
Thinning May be thinned with water as necessary.
Cleaning Clean up with water.
Typical
Specification
Grind thoroughly. Apply two coats E8490. (Contact A & I Coatings
for other requirements).
Note This product may be used with non-slip media to achieve various
anti-slip ratings. Contact A & I Coatings to discuss your
requirements.

Colour

Clear

Finish

Gloss (Full)